The DWT-200 Digital Torque Tester for Manual Wrenches is ideal for checking torque on manual torque wrenches up to 1,500 lbf-in with an accuracy of ± .5% F.S., ± 1 LSD. The tester features 3 measurement modes: Peak Down, Peak, or Real Time measurement modes and selectable units lbf-in, kgf-cm, N-m.

Yes-no decision conditions etc. can save five channels. .. A channel is only changed even if bolting conditions change. It is not necessary to reset up a maximum value and a minimum value one by one like former.

The main features:
-Yes-no decision 
-Average calculation
-Data storage is 800 affairs.
-A convenient functional setup of a setup of a measurement start value etc.
-Data output at real time (every about 1/180 seconds). 
-USB terminal data output

-It is a rechargeable battery drive, the installation to the spot is also easy.
-By the auto power OFF, It prevents forgetting to turn off the power.
-One-touch zero adjustment
-An auto clearance (0.1 0.5 1.0 1.5 2.0 2.5 3.0 sec) can be set up.
  It is very convenient for a continuous check.
-The operation torque of a QL type and pre set type wrench driver can read measured value correctly in peak down mode (P-D).


Specification DIS-IP05 DIS-IP5 <DIS-IP50 DIS-IP200 DIS-IP500
Measuring range
(at  time of Track)
2.0~500 mN・m
0.20~50 kgf・cm
0.20~45 lbf・in

0.020~5 N・m
0.20~50 kgf・cm
0.20~45 lbf・in

0.20~50 N・m
2.0~500 kgf・cm
2.0~450 lbf・in

2.0~200 N・m
20~2000 kgf・cm
20~1740 lbf・in

2.0~500 N・m
20~5000 kgf・cm
20~4500 lbf・in

Accuracy ±0.5%     (499 or less digit±3digit)
Display The 4 figures digital display of LCD
>The measurement direction CW-CCW (right and left)
P-P  Peak Peak load value hold.
T-R  Track Indication of real time torque value.
P-D  Peak down Holding Load Value at the moment to change from upward to downword
C Real-time output Load torque value is outputted every about1/ 180 second .
Setting of torque value A Maximum and a minimum value are in a measuring range, and a setup is possible.
Can confirm the set value by the buzzer sound or LED.
The Maximum, the minimum, and the average value The maximum, the minimum value, and average value of the saved data
Automatic Clearance Automatically clear the displayed value after certain time (0.5 - 3.0 sec,selectable at each 0.5 sec). Setting 0.0 sec for manual Zero clearance
One-touch zero Easy Zero-Adjustment with pressing CLEAR button
Data spec. Data transfer ASCII fomat (Baud rate :19200)
Data memory 800 data
Power supply Ni-Cd chargeable battery 1.2V×5cells  700mAh
Auto power save 10 minutes no use, automatically switch off.
about 3 hours
Continunous working time 12 hours
Meter outside type dimension 100(W) x105(D) x40 (H)  (It does not contain by the projection thing.)
Weight Meter part   520g
Code length Standard 1m (there are automatic machines no less than 4m as an option.)
AccessoriesBR>  (one piece each) AC/DC adaptor
An inspection report, a proofreading certificate, a traceability system figure
WhatsApp chat